Norcold N62X Installation Instructions Manual

Also see for N62X: Owner's instructions Service manual Service manual Owner's manual Owner's manual

Contents

Norcold N62X Installation Instructions Manual Manual pdf 7 page image

Installation Manual 7Reverse the Door Swing (optional)This refrigerator has door hinges that allow you to change thedirection the door opens by moving the hinges on a diagonal tothe opposite side.1. Remove the doors (See Art00986):- Remove the storage bins from the doors.- Remove and save both hinge pins [1] from each door.- Pull the door latch and remove each door away from therefrigerator.2. Change the position of the cabinet hinges and the strikeplate (See Art00987):- Remove and save the screws from the strike plate [2a].- Remove the two plastic hole caps that are near the strikeplate.- Remove the L-shaped plastic covers that are opposite thehinges.- Remove and save the screws from the upper cabinet hinge[3a] of each door.- Put each of these hinges on the other side of the refrigera-tor as the lower hinge [3b].- Attach each of these hinges with screws.- Remove and save the screws from the lower cabinet hinge[4a] of each door.- Put each of these hinges on the other side of the refrigera-tor as the upper hinge [4b].- Attach each of these hinges with screws.- Put the L-shaped plastic covers over the holes that wereused by the hinge screws.- Remove and save the screw from the front box [6].- Pull the front box away from the refrigerator and out fromunder the controls [7] (See Art00983).- Push the bottom trim piece [15] onto the front of the refrig-erator.- Put two screws [16] through the trim piece, the mountingflange, and into the floor.- Put screws through mounting flange on the rear of therefrigerator and into the floor.- Reverse the front box and put it on the opposite side of thecontrols.- Attach the front box to the refrigerator with the screw.- Put the strike plate on the opposite side of the refrigerator[2b].- Put the two round plastic caps into the holes that are nearthe strike plate.- Put plastic caps [8] into the holes that were used by the frontbox.3. Change the position of the door handles and the doorhinges (See Art00984 and Art00985):- Remove the plastic cap that is opposite the upper hinge ofthe upper door.- Remove the screws [9] from the door handle [10] and doorhinge [11].- Remove the round head screw [12] and door handle fromeach door.- Remove the upper hinge of each door.- Put each of these hinges on the other side of the door asthe lower hinge.- Attach each of these hinges with the screws that wereremoved from the other side.- The recommended torque for each cap screw is 35 in.-lbs.- Remove the lower hinge of each door.- Put each of these hinges on the other side of the door asthe upper hinge.- Attach each of these hinges with the screws that wereremoved from the other side.- Reverse each door handle and put the lower door handleon the upper door and the upper door handle on the lowerdoor.- Attach each door handle with a cap screw and a round headscrew.- Put the plastic cap into the hole that is opposite the upperhinge of the upper door.4. Reinstall the doors (See Art00986):- Make sure each hinge bushing [13] is in the correctposition.