Norcold N62X Owner's Manual

Also see for N62X: Owner's instructions Service manual Service manual Owner's manual Owner's manual

Contents

Norcold N62X Owner's Manual Manual pdf 15 page image

Owner’s Manual 15Replacement PartsYou may purchase replacement parts through your local RVdealer or authorized Norcold Service Center.Remove the RefrigeratorYour dealer or Norcold authorized service center must do thisprocedure.CAUTION: The rear of the refrigerator has sharp edgesand corners. To prevent cuts or abrasions when workingon the refrigerator, be careful and wear cut resistantgloves.1. Close the valve at the propane gas tank(s).WARNING: To avoid possible propane gas leaks,always use two wrenches to loosen and tighten the gassupply line connections.2. Remove the black AC power cord and the white ice maker ACpower cord (model N843-IM only) from the receptacle.3. Remove the DC wiring from the refrigerator:- Put a mark on the DC wires so you can put them back in thecorrect location.- Remove the DC fuse or remove the DC wiring from thebattery or the converter.- Remove the DC wires from the refrigerator.4. Open the lower intake vent and remove the gas supply linefrom the bulkhead fitting of the refrigerator.5. Remove the plastic plugs from the mounting flanges of therefrigerator.6. Remove the screws from the mounting flange at the rear ofthe refrigerator.7. Remove the screws from the upper and lower mountingflanges on the front of the refrigerator.8. Remove the refrigerator from the opening.Reinstall the RefrigeratorYour dealer or Norcold authorized service center must do thisprocedure.WARNING: Make sure the combustion seal is notbroken, is completely around the refrigerator mountingflanges, and is between the mounting flanges and thewall of the enclosure. If the combustion seal is notcomplete, exhaust fumes can be present in the livingarea of the vehicle. The breathing of exhaust fumes cancause dizziness, nausea, and in extreme cases, death.1. Push the refrigerator completely into the enclosure.2. Install the screws in the upper and then the lower mountingflanges on the front of the refrigerator.3. Install the screws in the mounting flange at the rear of therefrigerator.4. Put the plastic plugs into the mounting flanges of therefrigerator.WARNING: To avoid possible propane gas leaks,always use two wrenches to loosen and tighten the gassupply line connections.5. Attach the gas supply line to the bulkhead fitting of therefrigerator.6. Open the valve at the propane gas tank(s).WARNING: Do not allow the leak checking solution totouch the electrical components. Many liquids areelectrically conductive and can cause electrical shortsand in some cases, fire.7. Examine the gas supply line for leaks.8. Connect the DC wiring to the refrigerator:- Connect the DC wires to the refrigerator.- Install the DC fuse or connect the DC wiring to the battery orthe converter.9. Connect the black AC power cord and the white ice makerAC power cord (model N843-IM only) to the receptacle.- Clean the orifice assembly with air pressure and alcoholonly.- Using a wrench, assemble the orifice assembly to theburner.- Assemble the flare nut to the orifice assembly.- Examine all of the connections for gas leaks.- Clean the burner box.- Assemble the burner box cover.- Assemble the drip cup.