Norcold N62X Owner's Manual

Also see for N62X: Owner's instructions Service manual Service manual Owner's manual Owner's manual

Contents

Norcold N62X Owner's Manual Manual pdf 8 page image

Owner’s Manual 8Operating the Refrigerator Controls(N64X, N64XXX, N64XIM, N64XIMXX, N84X,N84XXX, N84XIM, and N84XIMXX models)Control panel:The refrigerator control panel (See Art01018) is between thefreezer compartment and the fresh food compartment. A 12 voltDC power supply is necessary for the control functions of therefrigerator to operate. The refrigerator receives DC power fromthe 12 volt system of the vehicle; either an auxiliary battery, aconverter, or the vehicle engine battery.The ON / OFF button [1] starts and shuts down the refrigerator:- To turn on the refrigerator, push and release the ON / OFFbutton.- To turn off the refrigerator, push the ON / OFF button for onesecond and then release.The TEMP SET button [3] controls the temperature adjustmentof the freezer and the fresh food compartment. The temperatureadjustment that you select does not change if the operationmode of the refrigerator changes.- Push the TEMP SET button and the temperature setting (thenumbers “1-9”) show in the center display [4].- The number “9” is the coldest temperature setting.- After a few seconds, the light bar beside AC goes offand the light bar beside LP GAS [6] shows.- After 10 seconds, the light bar beside LP GAS goes offand only the light bar beside AUTO remains.- This means that the refrigerator is operating onpropane gas.If an energy source is available to the refrigerator, but is notoperating correctly:- A fault code shows in the center display.- The refrigerator controls try to change to a less efficientenergy source.- If a less efficient energy source is not available:- A fault code shows in the center display.- Refer to the “Fault Codes” section of this manual.Set the controls to manual mode operation:- Push the ON / OFF button to turn the refrigerator on.- Push and hold the MODE button until the light bar showsbeside AC [4] and then release.- This means that the refrigerator is operating on ACelectric.- Push and hold the MODE button until the light bar showsbeside LP GAS [6] and then release.- This means that the refrigerator is operating onpropane gas.If the energy source is interrupted:- A fault code shows in the center display.- Refer to the “Fault Codes” section of this manual.