Nordic ID PL3000 User Manual
                                                                                           | |
Contents
| 
©2005 Nordic ID OyNordic ID PL3000 user manual, v. 2.4, March 2006 162.2.4 Installing the chargerFollow the instructions from the Charger Quick Guide to assemble the swivel to the charger body. Connectthe power cord to the power supply unit. Connect the power supply to the charger body. There are powercords with different plugs available. Use only a power supply supplied by Nordic Power AB. See the figure14.2.2.5 Charging the unitPlace the device into the charger as shown in figures 15. - 17. An indicator light on the top right cornerof the keyboard shows the charging status. When the battery is less than 90% capacity the light is red,when there is 90-100% capacity the light is orange. When the battery is full the light changes to green. Theminimum charging time for the initial charging is approximately 8 hours. Normal charging time is about 2½hours to 90% of the capacity and about 5 hours to full capacity.Remove the PL3000 from the charger by pressing the release buttons on the side of the charger. Theindicator light illuminates only when the unit is switched on or is on suspend mode. If the power level is verylow (below about 5%) the red indicator light remains illuminated when the unit is removed from charger. Inthis case charging should be continued.Fig.14 Connect the power supply to the charger bodyCharger bodyPower connectorPower supply cabelMini USB-ConnectorMini USB-cable |
Related manuals for Nordic ID PL3000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine