Nordic ID RF651 User Manual

Nordic ID RF651 User Manual Manual pdf 23 page image

© 2006 Nordic ID oyRF651 User Manual Version 1 June 200618��Preparing the Charger and the Nordic ID RF651Insert batteries to the RF651 as described earlier in this manual. Information on how to charge the rechargeable batteriescan be found in the chapter. When the batteries are in place the RF651 is ready for use and tries to connect to theBluetooth server and signals with a beeping sound.Software Installation Procedure1. Insert the RF651 installation CD into your CD-Rom drive• Setup Launcher starts automatically.• If the SetupLauncher doesn’t start, launch the SetupLaunch.exe manually from the cd.2. Install the Bluetooth Software (BTW)It’s possible to use NordicID PortRouter software and RF651 with the other distribution of WIDCOMM Bluetoothsoftware and other BT dongle presuming that the version of the software is 4.0.1.700 or later.If you have WIDCOMM Bluetooth software installed in your system and you want to keep it, you shall use your existingBluetooth USB adapter as well. In that case, skip this installation phase and go on to the “Install PortRouter”.To start installation pressing the “Install WIDCOMM Bluetooth software 4.0.1.xxxx” button the installation programinforms if there is already Bluetooth communication software installed. In case, there is Microsoft’s Bluetoothcommunication software installed, this installation removes it automatically. However, if there is other vendor’s Bluetoothcommunication software installed including WIDCOMM’s one not shipped in the RF651 package, it is STRONGLYRECOMMENDED that it will be uninstalled before you install WIDCOMM Bluetooth software from the CD delivered inthe RF651 package.If you are installing with a clean sheet (including exception of Microsoft’s Bluetooth software installed):• Press the “Install WIDCOMM Bluetooth software 4.0.1.xxxx” button and follow the instructions for the Bluetoothsoftware (BTW) installation.• Insert the Bluetooth dongle when the following window appears:After plugging in the Bluetooth dongle, this window disappears automatically. Note that it may take several secondsbefore installation continues. If installation does not continue within two minutes, please remove the Bluetooth dongleand plug it into another USB connector.As the “Bluetooth device not found” message box disappears, the “RF651 Setup Launcher” will be the top mostwindow. It locks the situation for a little while until it is possible to get the actual installation window active and topmost again by clicking its title bar.• After the installation reboot the computer and restart the SetupLauncher.exe from the cd.If you want to remove your current Bluetooth stack:• Choose “Add or Remove Programs” from the Windows Start menu, under “Settings”, “Control Panel”After having uninstalled your current Bluetooth software go on as though this would be a clean sheet installation.3. Install PortRouter• Press “Install Nordic ID PortRouter version x.x.x “ -button and follow the instructions of the PortRouter installationprogram.NOTE: After installation, the Bluetooth PIN code is set to “1234” in order to use it with the RF651.