NordicTrack NTB39020 User Manual

Contents

1225. Attach the Right Support (14) to a Weight RestArm (13) with two M10 x 25mm Screws (56).Rest the Weight Rest Arm (13) on the rightUpright (4).Repeat this step with the other Weight RestArm (13) and the Left Support (not shown).26. Make sure all parts of the weight rack are properly tightened. In addition, pull each cable a few timesto make sure the cables move smoothly over the pulleys. If the cables do not move smoothly, locateand correct the problem. When weights are used, the cables may be damaged if they are incorrectlyrouted. Refer to the CABLE DIAGRAMS on page 15 for correct cable routing.The use of all remaining parts will be explained in ADJUSTMENTS, beginning on the following page.2513 4145624. Wrap the Long Cable (43) around a 3 1/2” Pulley(34). Attach the Pulley and a Cable Trap (36) tothe Center Top Frame (9) with an M10 x 47mmButton Head Bolt (60), an M10 Washer (62), andan M10 Nylon Locknut (64). Make sure that theCable Trap is oriented to hold the Cable in thegroove of the Pulley and that the Cable Trapdoes not contact the Cable.2443646260 36349