NordicTrack NTB39020 User Manual

Contents

2362. Press a 50mm x 100mm Cap (23) into the RightFrame (3). Insert two M10 x 116mm CarriageBolts (53) up into the Right Frame. Note: TheRight Frame has a short weldment in the indi-cated location; the other side has a long weld-ment.Attach the Right Frame (3) to the Base Frame (1)with two M10 x 70mm Button Head Bolts (52),two M10 Washers (62), and two M10 NylonLocknuts (64). Do not tighten the Locknuts yet.Attach the Left Frame (not shown) to the BaseFrame (1) in the same manner.Orient an Upright (4) as shown. Attach theUpright to the Right Frame (3) with the two M10 x116mm Carriage Bolts (53) and two M10 NylonLocknuts (64). Do not tighten the Locknuts yet.Attach the other Upright (not shown) to theLeft Frame (not shown) in the same manner.3. Make sure there is a 60mm Square Cap (22) inthe top of the Center Upright (6).Orient the Center Upright (6) so that the lettersare on the indicated side. Attach the CenterUpright to the Base Frame (1) with two M10 x152mm Button Head Bolts (54), two M10Washers (62), and an M10 Nylon Locknut (64).Make sure the Washers and Locknut are onthe lower Bolt. Do not tighten the Locknut yet.643HighSideNumbersShortWeldment162 23525253464626254162264Letters onthis side