NordicTrack NTB58030 User Manual

Contents

87. Attach the Left Rear Upright (4) to the left FrontUpright (6) with four M10 x 94mm Bolts (34), twoSmall Joint Plates (15), and four M10 NylonLocknuts (32). Do not tighten the Locknuts yet.Repeat this step with the Right Rear Upright (notshown).8. Press two 48mm Round Inner Caps (23) into theends of the two Carriage Tubes (11). Screw theCarriage Tubes onto the Weight Carriage (10) asshown. Make sure the Carriage Tubes are fullytightened.78341561542323111110329. Route the Cable (31) up through the Lat Tower(8) and over an 89mm Pulley (26). Attach thePulley inside of the Lat Tower with an M10 x75mm Bolt (40), two M10 Washers (33), twoSpacers (28), and an M10 Nylon Locknut (32).Make sure the large ball on the Cable is in theindicated position.10. Wrap the Cable (31) over an 89mm Pulley (26).Attach the Pulley and a Cable Trap (27) to thebracket on the Lat Tower (8) with an M10 x 75mmBolt (40). Do not thread a Locknut onto theBolt yet. Make sure the Cable Trap is inside ofthe bracket and oriented to hold the Cable inthe groove of the Pulley.910LargeBall31408322833 263328312627408