NordicTrack NTB58030 User Manual

Contents

911. Wrap the Cable (31) around an 89mm Pulley(26). Attach the Pulley and a Cable Trap (27) tothe Weight Carriage (10) with an M10 x 45mmBolt (36) and an M10 Nylon Locknut (32). Makesure the Cable Trap is outside of the bracketand oriented to hold the Cable in the grooveof the Pulley.12. Wrap the Cable (31) around an 89mm Pulley(26). Attach the Pulley and a Cable Trap (27) tothe bracket on the Lat Tower (8) with the M10 x75mm Bolt (40) used in step 10 and an M10Nylon Locknut (32). Make sure the Cable Trapis oriented to hold the Cable in the groove ofthe Pulley.121131263227403110362732 26813. Route the Cable (31) through the Lat Tower Base(3) and around an 89mm Pulley (26). Attach thePulley to the bracket on the Lat Tower Base withan M10 x 45mm Bolt (36) and an M10 NylonLocknut (32).14. Route the Cable (31) under an 89mm Pulley (26)and through the Foot Plate (13) as shown. Attachthe Pulley to the Foot Plate with an M10 x 45mmBolt (36) and an M10 Nylon Locknut (32).Attach the Foot Plate (13) to the Lat Tower Base(3) with two M10 x 19mm Bolts (37) and two M10Nylon Locknuts (32). Do not tighten theLocknuts yet.Attach the Foot Plate (13) to the Bottom Crossbar(2) with two M10 x 94mm Bolts (34), two M10Washers (33), and two M10 Nylon Locknuts (32).Tighten all of the M10 Nylon Locknuts (32)used in steps 1–14.1314323133233323232 3233413313726233263636