NordicTrack NTE13920 User Manual

Contents

63141Grease484876769999 Tubes2. Identify the Pivot Axle (14), which is the longer of thetwo axles. Slide a Ramp Cover (48) onto an M6 x16mm Patch Screw (76) as shown. Tighten the PatchScrew into one end of the Pivot Axle. Apply a smallamount of the included grease to the Pivot Axle.Have a second person hold the two Ramp Spacers(99) against the sides of the Frame (1) so that theycover the indicated tubes on the Frame. Align theround tubes on the Ramp (3) with the Ramp Spacers.Make sure that the Ramp is turned as shown indrawing 3 below. Insert the Pivot Axle (14) into theRamp, the Ramp Spacers, and the Frame. If neces-sary, tap the Pivot Axle with a rubber mallet to insert it.Slide the other Ramp Cover (48) onto an M6 x 16mmPatch Screw (76) as shown. Tighten the Patch Screwinto the open end of the Pivot Axle (14).Tubes233. Slide an M6 Washer (64) onto an M6 x 16mm PatchScrew (76). Tighten the Patch Screw into one end ofthe Incline Axle (13). Apply a small amount of greaseto the Incline Axle.Raise the Ramp (3). Insert the Incline Axle (13) intothe welded tube under one side of the Ramp, throughthe motor screw, and then into the welded tube underthe other side of the Ramp. As you insert the InclineAxle through the motor screw, make sure that themotor screw does not turn.Slide an M6 Washer (64) onto an M6 x 16mm PatchScrew (76). Tighten the Patch Screw into the openend of the Incline Axle (13). 13GreaseMotorScrew64763 64764. Have another person hold the Upright (2) in the posi-tion shown. Make sure that the Upright is turned asshown in drawing 5 on page 7.Connect the Upper Wire Harness (115) to the LowerWire Harness (42). Carefully pull the upper end ofthe Upper Wire Harness to remove the slack fromthe Wire Harnesses. Insert the Upright (2) into theFrame (1). Be careful to avoid disconnecting orpinching the Wire Harnesses. Attach the Upright withtwo M10 x 110mm Button Screws (70), two M10 SplitWashers (73), and two Spacers (109); make sure thatthe curved sides of the Spacers are facing theUpright. Be careful to avoid damaging the WireHarnesses with the Button Screws.211570 42173731094109