NordicTrack NTE13920 User Manual

Contents

75851058611811986232423131185. Slide a Weld Spacer (119) onto the axle on the leftside of the Upright (2), with the open side of the WeldSpacer facing the Upright.Locate the Upper Body Arm (118) that has the LeftUpper Body Leg (31) inside of it (the Left Upper BodyLeg is marked with a sticker). Hold the Upper BodyArm with one hand, hold the Left Upper Body Leg withyour other hand, and slide the Upper Body Arm ontothe axle on the left side of the Upright (2). Then, slidethe Left Upper Body Leg out of the Upper Body Armuntil it rests on the Ramp (3).Have another person hold the Left Handlebar (24)near the Upright (2) as shown. Connect the left PulseSensor Wire (20) to the Pulse Extension Wire (114).Slide the upper end of the Left Handlebar (24) into thetube on the front of the Upright (2), while sliding thelower end of the Left Handlebar onto the axle on theleft side of the Upright. Attach the upper end of theLeft Handlebar with two M8 x 41mm Button Bolts (85)and two M8 Jam Nuts (86); be careful not to damagethe Wires (20, 114) as you insert the Button Bolts.Make sure that the Jam Nuts are resting in thehexagonal holes in the Left Handlebar. Attach thelower end of the Left Handlebar with an M8 x 38mmButton Bolt (105) and an M8 Jam Nut (86).Attach the other Upper Body Arm (118) and the RightHandlebar (23) to the Upright (2) in the same way.1142026962525226266. Look inside one of the Handlebar Covers (26) andlocate the square tabs connecting the two halves.Gently lift the tabs and disconnect the halves.Hold the two halves of the Handlebar Cover (26)around the tube on the left side of the Upright (2). Alignthe halves and press them together until they lock.Attach the other Handlebar Cover (26) to the right sideof the Upright (2) in the same way.Hold the halves of the Upper Handlebar Cover (25)around the tube on the front of the Upright (2); becareful not to damage the Wires (not shown).Attach the Upper Handlebar Cover with an M4 x 12mmScrew (96).6