Nordica INSERTO 60 Instructions For Installation, Use And Maintenance Manual

Also see for INSERTO 60: Instructions for installation, use and maintenance User manual

Nordica INSERTO 60 Instructions For Installation, Use And Maintenance Manual Manual pdf 21 page image

10. NORMAL OPERATIONAfter having positioned the registers correctly, insert the indicated hourly wood load avoiding overloads that cause anomalous stressesand deformations. You should always use the product with the door closed in order to avoid damages due to overheating (forgeeffect). The inobservance of this rule makes the warranty expire.With the registers located on the front of the device, it is possible to adjust the heat emission of the same. They have to be openedaccording to the calorific need. The best combustion (with minimum emissions) is reached when, by loading the wood, most part of the airfor combustion flows through the secondary air register.Never overload the appliance. Too much fuel and too much air for the combustion may cause overheating and then damage theproduct.You should always use the appliance with the door closed in order to avoid damages due to overheating (forge effect).The adjustment of the registers necessary to reach the rated calorific yield with a depression at the stack of 11 Pa 14 Pa (=1.1 =1.4 mmof column of water) is the following one: see chap. TECHNICAL DESCRIPTION. The appliance works as an intermittent operatingappliance.Besides the adjustment of the air for the combustion, the intensity of the combustion and consequently the thermal performance of thedevice is influenced by the stack. A good draught of the stack requires a stricter adjustment of air for combustion, while a poor draughtrequires a more precise adjustment of air for combustion.To verify the good combustion, check whether the smoke coming out from the stack is transparent.If it is white, it means that the device is not properly adjusted or the wood is too wet; if instead the smoke is gray or black, it signals that thecombustion is not complete (it is necessary a greater quantity of secondary air).WARNING: When fuel is added onto the embers in the absence of a flame, a considerable amount of fumes may develop. Should thishappen, an explosive mixture of gas and air may form, and in extreme cases an explosion may occur. For safety reasons it is advisableto perform a new lighting procedure with the use of small strips.10.1. OPERATION DURING TRANSITION PERIODSDuring transition periods when the external temperatures are higher, if there is a sudden increase of temperature it can happen that thecombustion gases inside the flue cannot be completely sucked up.The exhaust gases do not come out completely (intense smell of gas). In this case, shake the grating more frequently and increase the airfor the combustion. Then, load a reduced quantity of fuel in order to permit a rapid burning (growing up of the flames) and the stabilizationof the draught.Then, check that all openings for the cleaning and the connections to the stack are air-tight. In case of doubt, do not operate the product.11. SUMMER STOPAfter cleaning the hearth, chimney and hood, totally eliminating the ash and other eventual residues, close all the doors of the hearthand the relevant registers; in case you disconnect the appliance from the chimney you must close its openings in order to let work otherspossible appliances connected to the same flue.We suggest performing the cleaning operation of the flue at least once per year; verifying in the meantime the actual status of the ropeseals, which cannot ensure the good operation of the equipment if they are not in good condition and are not making a good seal! In thiscase the seals must be replaced.In presence of dampness in the room where the stove has been placed, we advise you to put absorbent salts into the hearth.If you want to keep for long the aesthetic look of the cooker it is important to protect its internal walls in row cast iron with neutral Vaseline.INSERTI IN GHISA 60 - 70 - 70H496090710 - IT-EN-DE-FR 21