Nordson iTRAX Product Manual
Also see for iTrax: Customer product manualQuick start guideQuick start guideCustomer product manual
                | |
Contents
| 
iTRAX Remote Display 7Part 1076079A 2007 Nordson CorporationConfiguration - Spray Monitor DataMake the following required and optional settings to configure the RemoteDisplay to display Spray Monitor data. See Figure 5 for the menu map.Mode Function, Range, and DefaultMODE Mode to enter: DISP (Display mode) or CONF (Configuration mode). Pressing the Selectkey while in Display mode automatically sets the mode to CONF. Select DISP to return todisplay mode from configuration mode. On power up the factory default is DISP.INTR Display Interval (1-60 seconds): Time to display each process data value. If more than oneprocess data is selected, each process data value is displayed for this time. The ProcessValue display scrolls through the process values and gun channels according to the PRIO(priority) setting. The factory default is 5 seconds.COMM Communications protocol: CAN1, CAN2, 485 (RS485). Set to CAN1 for Spray Monitors.The factory default is RS485.DATA Process data to display: BASE (base pressure), FIRE (fire pressure), GDUR (gun durationor spray time), G-ON (gun on time, or time it takes for gun to turn on), G-OF (gun off time,or time it takes for gun to turn off). The factory default is base pressure.UNIT Display units: ENGL (English) or METR (Metric). The factory default is English.GUNS Spray monitor network addresses (1-63) for the channels GUN1, GUN2, GUN3, and GUN4.The network address settings must be the same as the address switch settings of the spraymonitors.The channels GUN1-GUN4 correspond to the LEDs on the right side of the process display,from top to bottom. The LEDs light to indicate the channel for which process data is beingdisplayed.The factory default is GUN1=0001, GUN2-4=0000.PRIO Data display priority: GUN (Gun Priority) or DATA (Data Priority). If Gun Priority is selected and more than one gun channel is configured then a singleprocess data value is displayed for each channel in sequence, then the next configuredvalue for each channel. If only one channel is configured then the process data valuesare displayed in sequence for that gun. If Data Priority is selected all the process data values for one channel are displayed insequence, then all the process data values for the next channel are displayed insequence, and so on.For either priority, the gun LED lights while the process data values are displayed. |
Related manuals for Nordson iTrax
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine