Nortel 10 Installation Manual

Also see for Nortel 10: Safety instruction Product support bulletin Release note Installation and reference guide Installation instructions

Contents

Establishing a TCP/IP session using the managementmoduleTo establish a TCP/IP session for the GbE switch module using themanagement module, complete the following steps:1. Log on to the management module as described in the User’s Guide orCommand Line Interface Reference Guide for your management module. Ifnecessary, obtain the IP address of the management module from yoursystem administrator. The management-module window opens.Note: The User ID and Password fields are case-sensitive. Type yourinformation in uppercase letters only. To maintain system security,change your password after you log on for the first time. The defaultUser ID is USERID and the default password is PASSW0RD (where the Oin password is a zero).2. From the I/O Module Tasks menu, click Configuration.3. In the I/O Module Configuration section, click the bay number thatcorresponds to the location of the GbE switch module that you installed.4. In the IP address field in the New Static IP Configuration section, type thenew TCP/IP address of the GbE switch module; then, click Save.Note: The management module does not check for invalid IP addresses.5. Click Advanced Configuration. You can now start a Web session or aTelnet session.The Web interface and the Telnet program provide different ways to access thesame internal-switching software and configure it.v If your system application requires that you use the Web interface program,see “Configuring the GbE switch module using the switch-module BrowserBased Interface” on page 30 for additional information.v If your system application requires that you use the Telnet program, see“Configuring the GbE switch module using Telnet” on page 28 foradditional information.Chapter 5. Configuring the GbE switch module 27