/boot/gtimg imageX TADDR zzzzzWhere imagex is the image to install and zzzzz is the operating-systemimage file name.3. Reset and restart the GbE switch module as described in “Resetting andrestarting the GbE switch module.”4. At the CLI prompt, type the following command and press Enter./boot/gtimg boot TADDR yyyyWhere yyyy is the boot image file name.5. Repeat step3.Resetting and restarting the GbE switch moduleTo activate the new image or images, you must reset the GbE switch module.To reset the GbE switch module, complete the following steps:1. From the I/O Module Tasks menu, click Admin/Power/Restart. Themanagement module window opens.2. Select the I/O module bay on which the software update was just installed.3. Click Power Off Module(s).4. Select the I/O module bay on which the software update was just installed.5. Click Power On Module(s). Wait 60 seconds for POST to be completed.6. Click Monitors, and select Firmware VPD. The Firmware VPD windowopens.7. In the Firmware VPD window, locate the I/O Module Firmware VPDsection. Page down to the number of the I/O module bay that contains theGbE switch module that you just installed; then, note the correspondinglevel of the software for the GbE switch module. Confirm that the softwarebuild ID and revision reflect the correct software release.Chapter 6. Updating the software 35
