Installation and configuration 395— Getting Started Card• Ensure 1 Software License exists for each IP Phone 1150E beinginstalled.• Ensure the host Call Server is equipped with a voice Gateway MediaCard and a Signaling Server with the Line TPS application.• If an AC power adapter is required, ensure the approved Nortel globalpower supply (model number N0089601) is used. See Table 57 "IPPhone 1150E component list" (page 393).First-time installationYou must first install an IP telephony node with the Communication Server.For information about installing an IP telephony node, see Signaling ServerInstallation and Commissioning (NN43001-312) or IP Line Fundamentals(NN43100-500).CAUTIONDamage to EquipmentDo not plug your IP Phone 1150E into an ISDN connection.Severe damage can result.Configuring the IP Phone 1150EYou must configure the IP Phone 1150E before you can use it. UseProcedure 80 "Configuring an IP Phone 1150E" (page 395) to configure theIP Phone 1150E for the first time.Procedure 80Configuring an IP Phone 1150EStep Action1 Configure a virtual loop on the Call Server using LD 97.For more information about configuring a virtual loop, see IPLine Fundamentals (NN43100-500) and Software Input OutputAdministration (NN43001-611).2 Configure the IP Phone 1150E on the Call Server using LD 11. Atthe prompt, enter the following:REQ: chgTYPE: 1150For more information about configuring the IP Phone 1150E usingLD 11, see Software Input Output Administration (NN43001-611).Nortel Communication Server 1000IP Phones FundamentalsNN43001-368 01.02 StandardRelease 5.0 20 June 2007Copyright © 2003–2007, Nortel Networks.
