Connecting the components32Figure 7: Cable routing tracks and mounting holes8. Wall-mount your phone (optional). Your IP Phone 1140E can bemounted either by: (Method A) using the mounting holes on thebottom of the phone stand, or (Method B) using a traditional-stylewall-mount box with RJ-45 connector and 15-cm (6-inch) RJ-45 cord(not provided).Complete steps 1-7, as needed, before you wall-mount your phone:Method A: Press the wall-mount lever, and pull the phone away fromthe stand, as shown in Figure 5 on page 29. Using the stand cover(the part you removed in step 1), mark the wall-mount holes bypressing the bottom of the stand cover firmly against the wall in thelocation where you wish to install the phone. Four small pins on thebottom of the stand cover make marks on the wall. Use the marks asa guideline for installing the wall-mount screws (not provided). Installthe screws so that they protrude 3 mm (1/8 inch) from the wall, andthen install the phone stand mounting holes over the screw heads.You may need to remove the phone from the wall to adjust the lowerscrews. When the lower screws are snug, install the phone on the
