Nortel 2070 Configuration

Also see for 2070: Installation guide Troubleshooting guide

Contents

NORTEL TPS REMEDIATION MODULE FOR NVG—INSTALLATION AND CONFIGURATION RELEASE 4.7.0.2 PAGE 13Chapter 3: ConfigurationDefense Center and 3D Sensor configurationThe NVG can have a Client machine without Netdirect features (Clientless andEnhanced clientless). If a policy-violating IP traffic situation occurs from this IP, theTPS module will not kick out the machine even if the NVG has a sessioncorresponding to this IP in its session table.Creating remediations for the Defense Center and 3D SensorsUse the following procedure to create remediations for the Defense Center andthe 3D sensors.• On the DC, add a remediation instance for each NVG used with the DC.• Create specific remediations for each instance, based on the type ofresponse required on the NVG when compliance policies are violated.• Once remediations have been created, assign them to specific compliancepolicy rules.Instances on the Defense Center and 3D SensorsAfter installing NVG-TPS Module in the DC, add an instance.If there are multiple NVGs requiring remediations, a separate instance must becreated for each NVG.Adding a NVG instanceUse the following procedure to add an NVG instance:1. From the TPS main page, open the Policy & Response menu.2. Select Response.3. Select Remediations.4. Select Instances. The Remediation Instance List page appears.5. Click Add. The Edit Remediation Instance page appears.6. Enter a name for the instance in the Instance Name field.TIP: The name should contain no spaces or special characters and should bedescriptive.7. Enter the description in the Description field (optional).8. Enter the NVG Management IP address of the NVG used for the remediationin the NVG Mapped IP (MIP) field.9. Enter the administrator username for the NVG in the Username field.10. Enter the administrator password in the Password entry field and retype toconfirm the password.TIP: The password entered in both fields must match.11. Enter the default time out value in seconds for establishing a connection tothe NVG MIP. The default value is 10seconds