NORTEL TPS REMEDIATION MODULE FOR NVG—INSTALLATION AND CONFIGURATION RELEASE 4.7.0.2 PAGE 31Appendix A: Configuration ExamplesNVG TPS module configuration with NVG-TPS 1.4Figure 18: Save the compliance policy27. Activate the compliance policy.

Overview

Defense Center

Overall function

Interface between the DC and Perl script

Installation

Installing the remediation module

Configuration

Defense Center and 3D Sensor configuration

Creating remediations for the Defense Center and 3D Sensors

Kick the Client–IP remediation

Configuration Examples

Nortel 2070 Configuration

Chapter 1: Before you begin

IPS installation considerations

RNA installation considerations

Typical 3D Sensor deployments

Deploying a Multi-Port 3D Sensor

Other deployment options

Understanding detection engines and interface sets

Connecting sensors to your network

Using a Nortel Defense Center

Chapter 2: Installation

Security considerations

Setting the IP Address for the Management interface

Performing the initial setup

configuring the network settings

installing software updates

Console output

Installing the 3D Sensor 2x50/2x70

Chapter 3: Hardware specification

TPS 2x50 3D Sensor

Chassis front features

System operating environment

TPS 2x70 3D Sensor

Chassis dimensions

Chassis back I/O ports and features

Power supply

Safety information

Regulatory compliance

Appendix A: Safety and regulatory information

installation guide

2070

threat protection system troubleshooting guide

New in this release

Introduction

Navigation

Troubleshooting Fundamentals

Issues that require Sourcefire assistance

Hardware Troubleshooting

Ports to open in a firewall

Software Troubleshooting

Creating a troubleshoot file from a TPS device

Obtaining the troubleshoot file following a failed software upgrade

Resetting passwords

Resetting the Administrator Password for a TPS device

Installing an Old Version of SEU

Troubleshooting TPS Sensor when not receiving events

Troubleshooting the SFDataCorrelator

Troubleshooting alerting problems

Troubleshooting LDAP authentication

Configuring Snort through the User Interface

Verifying prohibit packet data on the DC

Scanning the NMAP

Threat Protection System Troubleshooting Guide

Troubleshooting Global Faults

Troubleshooting when no white list events are generated

Troubleshooting an IS that does not block traffic

Troubleshooting an IS that does not send email

Troubleshooting a failed upgrade

Troubleshooting when a customer is unable to add a sensor to be managed by a DC

Troubleshooting a system crash

Troubleshooting memory problems

Deploying between two network switches

Between a firewall and an endpoint

Checking IPv6 configurations on the CLI

Viewing remediation log

Emergency recovery trees

The TPS DC/ IS cannot receive events -- recovery tree

Reference to third party Application Guides

Contact Nortel technical support

Getting help from the Nortel Web site

Getting help from a specialist by using an Express Routing Code

Glossary


Contents Table Of Contents Overview Defense Center Overall function Interface between the DC and Perl script Installation Installing the remediation module Configuration Defense Center and 3D Sensor configuration Creating remediations for the Defense Center and 3D Sensors Kick the Client–IP remediation Configuration Examples	NORTEL TPS REMEDIATION MODULE FOR NVG—INSTALLATION AND CONFIGURATION RELEASE 4.7.0.2 PAGE 31Appendix A: Configuration ExamplesNVG TPS module configuration with NVG-TPS 1.4Figure 18: Save the compliance policy27. Activate the compliance policy. Previous Next / 35