Nortel 2330 Solution Manual

Also see for Secure Router 2330: Configuration guide Quick installation guide Installation guide Quick installation guide Installation

Contents

Nortel 2330 Solution Manual Manual pdf 54 page image

54 WLAN 2300 Series Outdoor Solution with Indoor Mounted APNN47250-503 (323847-C Version 02.01)Software installationCountry of operationBefore you can configure APs and radio parameters, you must specify the country in which you plan to operatethe radios. Since each country has different regulatory environments, the country code determines the transmitpower levels and channels you can configure on the radios. WSS software ensures that the values you canconfigure are valid for the country you specify.You must specify the country in which you plan to operate the WSS and its APs. WSS software does not allowyou to configure or enable the AP radios until you specify the country of operationThe country code is one of the parameters you set when you create a network plan. Be sure to select thecountry code for the country in which the AP will be operated. It is a violation of regulatory laws to set thecountry code to a country that is different than the actual country in which the AP is operating.For a complete listing of the two-letter country codes, refer to the "Approved Countries for the WLAN 2300Series Components" at http://www.nortel.com/support.Use of external antenna configuration option CLI and WMSSpecifying the external antenna modelTo specify the 2.4 GHz external antenna model using CLI, use the following command:set {ap port-list | dap dap-num} radio {1 | 2} antennatype {internal | 24143 | 24123 | 24113 |24203 | 24403 | 24453 | 24493 | 24553 | 24883 | mixed | 24143-OUT | 24143-OUT-10 |24143-OUT-25 | 24143-NEMA | 24143-NEMA-10 | 24143-NEMA-25 | 24123-OUT |24123-OUT-10 | 24123-OUT-25 | 24123-NEMA | 24123-NEMA-10 | 24123-NEMA-25 |24113-OUT | 24113-OUT-10 | 24113-OUT-25 | 24113-NEMA | 24113-NEMA-10 |24113-NEMA-25 | 24493-OUT | 24493-OUT-10 | 24493-OUT-25 | 24493-NEMA |24493-NEMA-10 | 24493-NEMA-25 | 24883-OUT | 24883-OUT-10 | 24883-OUT-25 |24883-NEMA | 24883-NEMA-10 | 24883-NEMA-25}To specify the 5.0 GHz external antenna model using CLI, use the following command:set {ap port-list | dap dap-num} radio {1 | 2} antennatype {internal | 5133 | 5303 | 5643 | 5173 |5103 | mixed | 5133-OUT | 5133-OUT-10 | 5133-OUT-25 | 5133-NEMA | 5133-NEMA-10 |5133-NEMA-25 | 5643-OUT | 5643-OUT-10 | 5643-OUT-25 | 5643-NEMA |5643-NEMA-10 | 5643-NEMA-25}Note. The options displayed are dependent upon the access point model number thatthis CLI command is executed against. The following example is for an Access point2330A.