Nortel 2340 Command Line Interface Manual

Also see for 2340: Installation guide Configuration guide

Contents

Nortel 2340 Command Line Interface Manual Manual pdf 13 page image

Using the Command-Line Interface 13Nortel WLAN — Location Engine 2340 Using the Command Line InterfaceCLI ConventionsYou should be aware of the following WLE2340 Software CLI conventions for command entry:• “Command prompts” on page 13• “Syntax Notation” on page 13Command promptsBy default, the WLE CLI provides the following prompt. For ease of presentation, this manual shows the enabledprompts as follows:WLE>WLE#For information about changing the CLI prompt on a WLE, see set prompt.Syntax NotationThe WLE2340 Software CLI uses standard syntax notation:• Bold monospace font identifies the command and keywords you must type. For example:Syntax set enable• A vertical bar (|) separates mutually exclusive options within a list of possibilities. For example, you enter eitherenable or disable, not both, in the following command:Syntax set ssh {enable | disable}