Nortel 312865-A Installation Manual
Also see for 1000BASE-XD: Using
                  | |
62 Verify that the GBIC is the correct model for your networkconfiguration (Table 1 on page 4).3 Remove the dust cover from the GBIC’s optical bores.4 Grasp the GBIC between your thumb and forefinger.5 Insert the GBIC into the slot on the front panel of the GigabitEthernet switching module (Figure 3) .Figure 3 Inserting the GBIC into the switching moduleRemoving a GBICThis section lists the steps for removing a GBIC.To remove a GBIC:1 Disconnect the network fiber cable from the GBICconnector.Note: GBICs are keyed to prevent incorrect insertion. |
Related manuals for Nortel 1000BASE-XD
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine