245.2 Documenting Radio Requirements and ResultsIf an agreement is made with the customer to accept areas where radio coverage is less thenacceptable, this should be documented and agreed upon with the customer.Note the results of the Deployment Survey on the relevant floor plan documents. Clearlydocument the location of the Deployment Base Station and the expected mounting location of thepermanent Base Station or Repeater and the coverage area provided from this location. Formulti-floor deployments, make sure to note the floor where the Deployment Base is located.Include in the documentation wiring considerations and special installation instructions.5.3 Deployment Steps5.3.1 Deployment in a Single Story Building1. Determine the outer points of the building for placing the Deployment Base Station.(points 1, 2 on figure A)2. Place the Deployment Base near point 1 at a height of 6-8feet/1.8-2.5m and begin themeasurement of the radio signal. Proceed at approximately a 45 degree angle awayfrom the Deployment Base. Mark on the map the boundary of the radio coverage cell.3. Move the Deployment Base Station to point 2 at a height of 6-8 feet/1.8-2.5m and in thesame technique measure the signal. Mark on the map the boundary of the radiocoverage.4. Continue to measure and document the radio signal from each of the main points on themap. A center crossing point will indicate the possible best location for mounting thepermanent Base Station.5. Once identified, place the Deployment Base in the center of the area at the point whereeach of the coverage cells crossed during deployment. Verify the coverage of the cellreaches all areas expected.Figure A Deployment BaseFinal Base124356123456Figure A Deployment BaseFinal BaseFigure A Deployment BaseFinal Base124356123456In some deployments it will be found that the placement of the deployment Base Station will notoverlap with the Deployment Base Station as indicated on the map below. To deploy in theseenvironments:1. Mark the corners of the area to be deployed. (Position 1 and 2 on figure B)NN40110-304 1.1