24 Small form factor pluggable transceiversModel Product number Description1000BASE-XD AA1419051-E6 1550 nm, up to 40 km1000BASE-ZX AA1419052-E6 1550 nm, up to 70 km1000BASE-XD CWDM AA1419053-E6 toAA1419060-E6 1470 nm to 1610 nm, up to 40 km1000BASE-ZX CWDM AA1419061-E6 toAA1419068-E6 1470 nm to 1610 nm, up to 70 km1000BASE-BX AA1419069-E6,AA1419070-E6Bidirectional 1310 nm and 1490 nm, upto 10 kmFor specifications for these SFPs, see "SFP specifications" (page 49).Installing an SFPInstall an SFP to provide an interface between the switch and the networkcable.Installing an SFP takes about 3 minutes.Prerequisites• Verify that the SFP is the correct model for your network configuration.Procedure stepsCAUTIONSFPs are keyed to prevent incorrect insertion. If the SFP resistspressure, do not force it; turn it over, and reinsert it.Step Action1 Remove the SFP from its protective packaging.2 Grasp the SFP between your thumb and forefinger.3 As shown in the following figure, insert the device into the slot onthe module.Apply a light pressure to the device until it clicks and locks intoposition.Nortel Ethernet Routing Switch 8600Installation — SFP, XFP, GBIC, and OADM Hardware ComponentsNN46205-305 01.02 Standard4.1 16 November 2007Copyright © 2007, Nortel Networks.
