Nortel Remote Gateway 9110 Installation And Administration Manual

Also see for 9110: Reference guide Release note Reference guide Release note Quick start guide

Contents

Nortel Remote Gateway 9110 Installation And Administration Manual Manual pdf 82 page image

58 Remote Gateway 911x Series Installation and Administration GuideInstalling the Remote Gateway 911x series unit Standard 3.0Installing the Remote Gateway 9110circuit cardBefore you can install the Remote Gateway 9110 circuit card, you must firstremove the footstand of the digital telephone. For more information aboutsupported telephone footstands, refer to “Required footstand for RemoteGateway 9110 units” on page 26.Note: You can only add the Remote Gateway 9110 circuit card to digitaltelephones that have an ATA/MCA footstand. To obtain an ATA/MCAfootstand, contact your Nortel distributor.Removing the footstand of the digital telephone setTo remove the footstand of the digital telephone set:1 Disconnect the telephone-side connection of the RJ-11 TCM telephonecable. The other end of this cable connects to the wall jack.2 Place the telephone on a flat surface with the keypad facing downward.Note: Ensure that you are grounded with an approved ESD strap.