62 Installing Secure Router 2330/4134 hardware componentsPrerequisites• You must save your configuration. If you do not save your currentconfiguration before hot swapping a module, the Secure Router2330/4134 uses the last saved configuration. To save yourconfiguration, enter save local.• Ensure you have the replacement interface module ready to install.Procedure stepsStep Action1 To verify that the Secure Router 2330/4134 recognizes theinterface module, enter:show chassisProceed with the hot swap of the interface module if, and only if,the interface module appears in the list of installed modules onthe Secure Router 2330/4134. If the interface module does notappear in the list of installed modules, see Nortel Secure Router2330/4134 — Troubleshooting (NN47263-700).2 To access the configuration mode, enter:configure terminal3 To select the interface module you want to shutdown, enter:chassis module Do not enter a port number.4 To shut down the interface module, enter:shutdownIt can take longer for the Mediation Server Module to shut downcompared to other modules because the Mediation ServerModule must wait for the Windows Server 2003 operating systemto shut down properly.5 To verify the change in status of the module, enter:show chassis6 Remove the interface module from the Secure Router2330/4134.7 Move the cables from the module you removed to thereplacement module.You must connect each cable in the same port on thereplacement module that the cable occupied in the module youremoved.8 Insert the replacement interface module in the slot, securing itfirmly with the captive screws. Ensure you are in configurationmode, then enter the following command to select thereplacement module:chassis module Nortel Secure Router 2330/4134Installation — Hardware ComponentsNN47263-301 03.01 7 September 2009Copyright © 2007-2008 Nortel Networks. All Rights Reserved.