Nortel T7406 Installation Manual

Also see for T7406 Phone: Installation guide User's card Manual

Contents

10 Chapter 1 About your T7406 PhoneP0606142Mounting BracketT7406 Pre-installation ProgrammingBefore connecting the T7406 base station to your system, you must set up system programmingfor the handset lines.Have the system administrator set up this programming:1 Program Handsfree to Auto.2 Program a maximum of three lines to each handset.3 Assign Ring & Appear on the lines you assign to the handset.4 Set the Page zone to None.5 Set DND on Busy to Yes if you do not want your calls interrupted with a ring tone when asecond call comes in. Instead, the button flashes, indicating an incoming call.6 Other telephone programming is the same as for the M7310 telephone, with the exception ofthe memory key locations.Before you start• Ensure there is an AC power outlet within 1.5 meters (5 feet) of the base station location.Note: Appear only does not allow the handset to wake from Handset Asleepmode.Note: Handsets can send Page announcements, but they cannot receive them.MountingbracketNotches match to bracket.