Web OS 10.0 Application Guide178 n Chapter 7: Filtering 212777-A, February 2002IP Address RangesYou can specify a range of IP addresses for filtering both the source and/or destination IPaddress for traffic. When a range of IP addresses is needed, the source IP (sip) address or des-tination IP (dip) address defines the base IP address in the desired range. The source mask(smask) or destination mask (dmask) is the mask that is applied to produce the range.For example, to determine if a client request’s destination IP address should be redirected tothe cache servers attached to a particular switch, the destination IP address is masked (bit-wiseAND) with the dmask and then compared to the destination IP address.As another example, the switch could be configured with two filters so that each would handletraffic filtering for one half of the Internet. To do this, you could define the following parameters:Cache-Enabled versus Cache-Disabled FiltersTo improve efficiency, by default, the Web switch performs filter processing only the firstframe in each session. Subsequent frames in the session are assumed to match the same criteriaand are automatically treated in the same fashion as the initial frame. These filters create a ses-sion entry in the Web switch and are known as cache-enabled.Some types of filtering (TCP flag and ICMP message type filtering) require each frame in thesession to be filtered separately. These filters are known as cache-disabled.All filters are cache-enabled by default. To change the status of a filter, use the following com-mands:N OTE – Cache-enabled filters should not be applied to the same ports as cache-disabled filters.Otherwise, the cache-disabled filters could potentially be bypassed for frames matching thecache-enabled criteria.Table 7-3 Filtering IP Address RangesFilter Internet Address Range dip dmask1 0.0.0.0 - 127.255.255.255 0.0.0.0 128.0.0.02 128.0.0.0 - 255.255.255.255 128.0.0.0 128.0.0.0>> # /cfg/slb/filt /adv (Select the advanced filter menu)>> Filter 1 Advanced # cache ena|dis (Enable or disable filter caching)
