Nortel i2050 Installation Manual

Also see for i2050: Description User guide

Contents

Chapter 4 Nortel Networks i2050 Diagnostic Utility 45i2050 Software Phone Installation GuideTable 6 Audio connection dataData DescriptionStream Volume Volume of the audio stream indicated in percentage.Alerting Volume Volume of the alerting tone indicated in percentage.Audio Started Time the last (or current) audio connection started. A currently active audio stream is indicated bythe comment Active. If there is no currently active audio stream, this is indicated by the commentLast Connection.Receive StreamConnectedTime the last (or current) audio receive stream connection started. A currently connected audiostream is indicated by the comment Connected. If there is no currently connected receive stream,this is indicated by the comment Last Connection.TransmitStreamConnectedTime the last (or current) audio transmit stream connection started. A currently connected audiostream is indicated by the comment Connected. If there is no currently connected transmit stream,this is indicated by the comment Last Connection.Receive Stream The number of packets and bytes of audio received during the last (or current) connection. Thetime indicates the last time this was updated. Updates occur every 1000 packets.TransmitStreamThe number of packets and bytes of audio transmitted during the last (or current) connection. Thetime indicates the last time this was updated. Updates occur every 1000 packets.StreamsDisconnectedThe last time the audio streams were disconnected.Receive StreamClosedThe last time the receive audio stream was closed.TransmitStream ClosedThe last time the receive audio stream was closed.Audio Stopped The time the audio was stopped.Mute Status Mute status on the i2050 Software Phone is indicated by the color red appearing on the mutebutton. This indication is controlled by the Terminal Proxy Server (TPS). The TPS uses differentmessages to control the state of the mute button and the actual mute condition of the audio. It ispossible that these two values can get out of sync. The Mute status value here indicates the mutestatus of the audio stream as opposed to the button status.A second mute control exists. It is shown in the Current User Data section under HeadsetMicrophone.Source: Mute status of the audio streamCurrent 802.1p(Requires NICSupport)Indicates if the i2050 Software Phone believes it is sending 802.1p (on) or not (off). This may ormay not be true, depending upon whether the NIC (Network Interface Card) actually supports802.1p. If the NIC does not support 802.1p, an on indication here does not mean the computer isactually sending 802.1p.Jitter The jitter parameters used for the last (or current) call. The time of the last jitter update is indicated.If the computer is overriding the Communications Server assigned jitter values (Advanced AudioOverride Communications Server values), this is indicated in the System Data section under LocalJitter Settings.Source 1: Advanced Audio Use Communications Server valuesSource 2: Advanced Audio Override Communications Server valuesOpen RXStreamThe parameters for the last (or current) receive audio stream. The time indicates when the streamwas opened. Codec selection, frames per packet, RTP/RTCP ports, RTP/RTCP DiffServ and802.1p values are reported here. If there is a currently open receive stream, this is indicated by thecomment Active.Open Tx Stream The parameters for the last (or current) transmit audio stream. The time indicates when the streamwas opened. Codec selection, frames per packet, RTP/RTCP ports, RTP/RTCP DiffServ and802.1p values are reported here. If there is a currently open transmit stream, this is indicated bythe comment Active.