Notifier SFP-5UD(C)/E Operating Instructions Manual

Contents

operating instructions

WHEN AUDIBLE DEVICES ARE SOUNDING -FOR AN ALARM1. Evacuate the protected area2. Notify the monitoring service and/or the Fire Department immediately. Tell them briefly what happened and whatyour current status is.Phones: ____________________________ _________________________________Fire Department Monitoring Service3. If the Fire Department is responding, be prepared to provide directions to arriving firefighters.FOR TROUBLE ONLY1. Notify the monitoring service and/or Fire department if this panel is connected to either one, and tell themwhat is happening.2. Silence audible devices by unlocking and opening the panel and pressing the ACKNOWLEDGE/STEP button. TheTROUBLE indicator will remain illuminated yellow. Contact authorized service personnel immediately! (See Below).WARNING!DO NOT ALLOW TROUBLE CONDITIONS TO REMAIN LOGGED IN THE SYSTEM.THE PROTECTION THE SYSTEM OFFERS HAS BEEN COMPROMISED, OR ELIMINATED WHEN ATROUBLE CONDITION EXISTS.To return to normal after an alarm1. Do not enter the protected area until safe to do so.2. Clear all initiating devices. Smoke detectors will not resetif there is still smoke in the area.3. Reset the control panel (PRESS the RESET button)Power failure or brownoutIf AC power drops too low or fails, AC POWER indicator willextinguish, the system TROUBLE indicator will turn on yellow, andthe panel buzzer and any other audible trouble devices will sound.Contact authorized service personnel immediately. See below.Manual activation (Fire Drill or otherwise)Notification Appliance Circuits (NACs) can be activated bypressing and holding the DRILL button for at least twoseconds.NOTE: You may want to disconnect municipal box by slidingDISCONNECT switch, located on 4XTM module, to itsdisconnect position (to the right). If a DACT is con-nected, notify the monitoring service before conductingany fire drills or tests.SFP-5UD(C)/E & SFP-10UD(C)/E Fire Alarm Control PanelOperating InstructionsPANEL KEY - The key to open the panel can be found at thefollowing location:NORMAL - Only AC POWER is illuminated green.All other indicators are off. LCD display will read SYSTEMALL NORMAL.Document #53132 Rev. A 3/22/07 ECN 06-285THIS SHEET SHALL BE FRAMED ADJACENT TOTHE CONTROL PANELTo test the indicators, LCD display and piezoPress and release the RESET button and check all indicators/LEDs. Every indicator/LED should be on, LCD shows all pixelson, piezo sounder beeps.For more information, refer to the SFP-5UD/E & SFP-10UD/EManual, Document #52879. It is kept in the following location:Alarm SilencingNotification Appliance Circuits may be silenced by pressing theALARM SILENCE button. ALARM SILENCED will turn on yellow.Subsequent alarms will reactivate circuits. Press the RESETbutton to clear the "silenced" condition.NOTE: Notification Appliance Circuits may be programmed asnonsilenceable. Also, Signal Silence Inhibit, if enabled, willprevent silencing of NACs for one minute after an alarm (seemanual).Name: _____________________________________Company: _________________________________Address: ___________________________________Telephone Number: ________________________In the event of trouble, contact thelocal Notifier Service Representative

/ 1

Related manuals for Notifier SFP-10UD(C)/E