Novacor Diasys Integra Access Manual
                                          | |
Contents
| 
6. How the unit functions6.1. Start up(Mode selector in measurement position)Before putting the Diasys in its pouch, check that the modeselector is in the MEASUREMENT position and that theunit is not connected to a terminal (indicated by ìCOMMîor ìMODî on the display).To start up the unit, keep the pink key pressed down andrelease it after the fourth beep.One of the following messages will be displayed for 10seconds:Battery replaced since previous start up.Battery not replaced since previous start up (battery shouldbe charged).Press the pink key briefly during this 10 second display andmonitoring will be initiated in the oscillometric mode.6.2. Test measurements(Mode selector in measurement position)At the start of the monitoring, the Diasys Integra Accessautomatically carries out two test measurements inoscillometric mode separated by a two minute interval(with a minimum of 30 seconds between the end of the firstand the beginning of the second).These measurements allow the Diasys to adapt themonitoring parameters.PMPM28 ï Diasys Integra Access - Manual - GB - Rev 2 |
Related manuals for Novacor Diasys Integra Access
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine