Novation Nova Owner's Manual

Contents

Novation Nova Owner's Manual Manual pdf 103 page image

polyphony would automatically change to Polyphonic. In Program mode, the display is different. It shows “Program Mode” on thetop line of the display & “Polyphony” on the bottom line. When in Program mode, use the lower Fast Data knob & nudge buttons toadjust this parameter. The range of this parameter in the Performance mode is Off, Poly , Mono. & Prog. In the Program mode therange is Poly & Mono. This parameter is memorised with Programs in Program Mode & Performances in Performance Mode.When this button is pressed when in Program mode the display shows:When in Program mode, the display is different but the function is the same. Use the lower Data knob to adjust this parameter. Therange of this parameter in the Program mode is Off, Poly , Mono. & Prog. In the Program mode the range is Poly & Mono. Thisparameter is memorised with Programs in Program Mode & Performances in Performance Mode.Range - ButtonThis button only works in Performance mode.This button alters the Key Range of the currently selected Part. When this button is pressed, the display shows parameters rele-vant to this section. There are a maximum of 2 parameters displayed. One for each line on the display. The “Fast Data” Knobs onthe right of the display are used to alter these parameter’s values.When this button is pressed the display shows:As can be seen the higher parameter is “Highest note”. In this case with a value of C8.This parameter selects the Highest note the currently selected Part will play on & is adjusted using the higher Fast Data knob. Therange of this parameter is C0 to C8 . This parameter is memorised with the Performance.As can be seen the lower parameter is “Lowest note” In this case with a value of C0.This parameter selects the Lowest note the currently selected Part will play on & is adjusted using the Lower Fast Data knob. Therange of this parameter is C0 to C8 . This parameter is memorised with the Performance.If the Lowest note is set higher than the Highest note, a reverse window can be created. For example:If Part Highest key is set to C2 & Part lowest key is set to C3. The sound appears on the keyboard from C0 to C2 & from C3 to C8.In other words there is a “Hole” in the middle of the keyboard.The Range for the Part can be set via MIDI by holding down the page up ( for the Highest note ) or page down ( for the Lowestnote ) buttons & while holding down, playing a note into the Nova the desired split point. You can set both parameters simultane-ously by holding down both page buttons.Solo - ButtonThis button works only in performance mode.Pressing this button ( Solo button is lit ) solos the currently selected Part. All other Parts flash to indicate they are muted.The Solo mode can be cancelled by pressing the Solo button again ( Solo button is unlit ).Solo mode is cancelled when a new Performance is selected.NOTE:NOTE:NOTE:NOTE:NOTE:NOTE:Highest note C8Lowest note COProgram modepolyphony MonoPART EDIT SECTION101