Additional Installation InformationA117novdocx (en) 13 May 2009AAdditional Installation InformationThe following sections contain additional information to help you install Novell® ZENworks®Linux Management: Section A.1, “Installation Options,” on page 117 Section A.2, “Automating Installation of the ZENworks Agent,” on page 118 Section A.3, “Installing ZENworks Linux Management on a SLES 9 Server with a MinimalInstallation,” on page 119 Section A.4, “Installing ZENworks Linux Management on a SLES 10 Server with a CustomizeInstallation,” on page 119 Section A.5, “Installing a ZENworks Server on a Device Configured with DHCP,” on page 121A.1 Installation OptionsWhen you installed Novell ZENworks Linux Management on a ZENworks Primary Server or onsecondary ZENworks servers as described in Section 5, “Installing the ZENworks Primary Server,”on page 41 or Section 6, “Installing a ZENworks Secondary Server,” on page 47, you performed astandard installation without using additional installation options.When you installed ZENworks Agent on managed devices as described in Section 7.2, “Installingthe ZENworks Agent and Registering the Device,” on page 54, you used the -a or -o installationoptions.NOTE: If you are performing an upgrade from a previous version of ZENworks LinuxManagement, as explained in “Upgrade” on page 71, you can use upgrade options with the zlm-upgrade command. For more information, see “Upgrade Options” on page 91.The following options can be used with the zlm-install command:Table A-1 Options that can be used with the ZLM-install commandOption Description-p Prompt before adding each package.-s Run silently using data from a previous configuration. Specify the response file that youwant to use. This is the response file that you recorded user input by using the -rcommand. The following command shows the option’s usage:zlm-install -s config_file-r Record user input, including passwords, to be used in future silent-configurationinstallations. Specify the response file that you want to record the user input to. This is theresponse file that you use with the -s command to run a silent configuration. The followingcommand shows the option’s usage:zlm-install -r config-file-a Install only agent portions of ZENworks Linux Management.
