90 Novell ZENworks 7.2 Linux Management Installation Guidenovdocx (en) 13 May 20092 Execute the /usr/bin/rug bin -y upgrade_bundle_name command, whereupgrade_bundle_name is the upgrade bundle in the catalog assigned to the managed device.IMPORTANT: It takes approximately five minutes for the upgrade bundle to be installed andfor the upgrade process to be performed. Do not perform any rug commands such as rug refduring the upgrade process. Executing rug commands during the upgrade process might causethe process to fail.After the upgrade completes, you can verify that the upgrade was successful by executing therug ping command or refer to upgrade.log. The upgrade was successful if the version of zmdis 7.2.0. If you perform the rug ping command prematurely, you receive an exceptionmessage. You can recover by stopping and restarting zmd. The /tmp/zmd/upgrade.log mustcontain the “Starting ZENworks Management Daemon...” message in the last line.3 If the device does not have the X Window System installed:3a In ZENworks Control Center, click the upgrade bundle.3b Click the Details tab.3c In the Packages panel, select the following packages:novell-zenworks-x11vnc-0.6.1-2novell-zenworks-zmd-gconfpolicyenforcers-7.2.1-0novell-zenworks-tightvnc-1.2.9-6, zen-updater-7.2.1-0.13d Click Action > Set Freshen.4 (Optional) If SLES 10 or SLED 10 are running on DELL server and the managed devices havethe default zmd agent installed, do the following if you want to collect the Dell inventory of thedevices:4a In the Packages panel, select novell-zenworks-zmd-oem.4b Click Action > Unset Freshen.11.2 Increasing the Security Level AfterUpgrading a ZENworks Server from ZENworks 7Linux Management with IR1If you upgrade a ZENworks Server from ZENworks 7 Linux Management with IR1 to ZENworks7.2 Linux Management, the default PostgreSQL database security level requires authentication, butyou can optionally increase the security level of the database. In most corporate settings, thePostgreSQL database resides on a corporate LAN with firewall protection. If you want to increasethe security level of the database, edit the /var/lib/pgsql/pg_hba.conf file to add the IP addressand subnet mask for the ZENworks Primary Server and for all ZENworks Secondary Servers as wellas for the local host. An unedited file has a series of zeroes in place of the IP addresses and subnetmasks; you replace the zeroes with the information for your primary and secondary ZENworksservers.If you upgrade from ZENworks 7 Linux Management - Dell* Edition, this process is not necessary.See the PostgreSQL documentation for more information.
