INSTALLATION INSTRUCTIONSREAD & SAVE THESE INSTRUCTIONS!Bathroom ExhaustFan/Fluorescent LightCombinationMODEL: 769RFFOR BEST RESULTSWhen installing the Exhaust Fan/Light in a newconstruction site, install housing during the rough-inconstruction of the building. The blower unit and grille shouldbe installed after the finished ceiling is in place.To install the Exhaust Fan/Light in an existing finishedbuilding see instructions page 4.FIGURE 1IMPORTANT SAFETY INSTRUCTIONSWARNING: TO REDUCE THE RISK OF FIRE.ELECTRIC SHOCK, OR INJURY TO PERSONS,OBSERVE THE FOLLOWING:A. Use this unit only in the manner intended by themanufacturer. If you have questions, contact themanufacturer.B. Before servicing or cleaning unit, switch power off atservice panel and lock service panel to prevent power frombeing switched on accidentally.When the service disconnecting means cannot be locked,securely fasten a prominent warning device, such as a tag,to the service panel.CAUTION:For general ventilating use only. Do not use to exhausthazardous or explosive materials and vapors.INSTALLATION INSTRUCTIONSWARNING: TO REDUCE THE RISK OF FIRE,ELECTRIC SHOCK, OR INJURY TO PERSONS,OBSERVE THE FOLLOWING:A. Installation work and electrical wiring must be done byqualified person(s) in accordance with all applicable codesand standards, including fire-rated construction.B. Sufficient air is needed for proper combustion andexhausting of gases through the flue (chimney) of fuelburning equipment to prevent back drafting. Follow theheating equipment manufacturer's guideline and safetystandards such as those published by the National FireProtection Association (NFPA), and the American Societyfor Heating, Refrigeration and Air Conditioning Engineers(ASHRAE), and the local code authorities.C. When cutting or drilling into wall or ceiling, do not damageelectrical wiring and other hidden utilities.D. Ducted fans must always be vented to the outdoors.E. If this unit is to be installed over a tub or shower, it must bemarked as appropriate for the application.F. NEVER place a switch where it can be reached from a tubor shower.• The exhaust fan consists of the housing, power unit/blowerassembly (motor, wheel, mounting plate,) grille/lensassembly, reflector/lamp plug assembly (lamps notfurnished) and duct collar.• WARNING: To reduce the risk of fire or electric shock,do not use this fan with any solid-state speed controldevice.• Not for use in kitchens.• For installation in sloped ceilings up to 12/12 pitch.• Ductwork must point up.DUCT COLLARHOUSINGSLOTSTABSPOWER UNIT/BLOWERASSEMBLYGRILLEREFLECTORLENS• SUITABLE FOR USE OVER A TUB ORSHOWER WHEN INSTALLED IN A G.F.C.I.PROTECTED BRANCH CIRCUIT.• DO NOT INSTALL IN A CEILING INSULATED TO AVALUE GREATER THAN R-40.