NuTone Allure WS2 SERIES Instructions Manual

Also see for ALLURE WS2 SERIES: Instructions Instructions Instructions

Contents

Page 1ALLURE ® WS2 SERIESRANGE HOOD!WARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURYTO PERSONS, OBSERVE THE FOLLOWING:1. Use this unit only in the manner intended by the manufacturer. Ifyou have questions, contact the manufacturer at the address ortelephone number listed in the warranty.2. Before servicing or cleaning unit, switch power off at service paneland lock the service disconnecting means to prevent power frombeing switched on accidentally. When the service disconnectingmeans cannot be locked, securely fasten a prominent warningdevice, such as a tag, to the service panel.3. Installation work and electrical wiring must be done by a qualifiedperson(s) in accordance with all applicable codes and standards,including fire-rated construction codes and standards.4. Sufficient air is needed for proper combustion and exhausting ofgases through the flue (chimney) of fuel burning equipment toprevent backdrafting. Follow the heating equipment manufacturer’sguideline and safety standards such as those published by theNational Fire Protection Association (NFPA), and the AmericanSociety of Heating, Refrigeration and Air Conditioning Engineers(ASHRAE), and the local code authorities.5. When cutting or drilling into wall or ceiling, do not damage electricalwiring and other hidden utilities.6. To reduce the risk of fire or electric shock, do not use this rangehood with an additional speed control device.7. Ducted fans must always be vented to the outdoors.8. To reduce the risk of fire, use only metal ductwork.9. Use with approved cord-connection kit only.10. This unit must be grounded.TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:1. Never leave surface units unattended at high settings. Boiloverscause smoking and greasy spillovers that may ignite. Heat oilsslowly on low or medium settings.2. Always turn hood ON when cooking at high heat or when cookingflaming foods.3. Clean ventilating fans frequently. Grease should not be allowed toaccumulate on fan or filter.4. Use proper pan size. Always use cookware appropriate for the sizeof the surface element.TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENTOF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metaltray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.If the flames do not go out immediately, EVACUATE AND CALLTHE FIRE DEPARTMENT.2. NEVER PICK UP A FLAMING PAN — You may be burned.3. DO NOT USE WATER, including wet dishcloths or towels - violentsteam explosion will result.4. Use an extinguisher ONLY if:A. You know you have a Class ABC extinguisher and you alreadyknow how to operate it.B. The fire is small and contained in the area where it started.C. The fire department is being called.D. You can fight the fire with your back to an exit.* Based on “Kitchen Fire Safety Tips” published by NFPA.READ AND SAVE THESE INSTRUCTIONSInstaller: Leave this manual withthe homeowner.Homeowner: Operating andcleaning information on page 6.CAUTION1. For indoor use only.2. For general ventilating use only. Do not use to exhaust hazardousor explosive materials and vapors.3. To avoid motor bearing damage and noisy and/or unbalancedimpellers, keep drywall spray, construction dust, etc. off powerunit.4. For best capture of cooking impurities, your range hood shouldbe mounted so that the top of the hood is 24” to 30” above thecooking surface.5. Please read specification label on product for further informationand requirements.TABLE OF CONTENTSThis manual is divided into sections as follows:PREPARE HOOD LOCATIONRun ductwork from roof or wall cap, and electrical wiring fromservice panel - to installation location.PREPARE HOODGet your hood ready for installation.CONNECT WIRINGMake electrical wiring connections to hood.INSTALL HOODSecure hood to cabinet and ductwork - install bulbs and filters.OPERATIONHow to use the hood controls.CLEANINGKeep your hood in top working condition.SERVICE PARTSPart numbers and exploded view of hood components.WARRANTYOne-year limited warranty and how to contact us.NOTE If hood is to be installed Non-Ducted:Purchase a set of (2) non-ducted filters from your localdistributor or retailer and attach them to the aluminummesh filters.Patent No.:US D450, 829 S! FOR DOMESTIC COOKING ONLY !ALLURE®WS2 SERIES RANGE HOODRegister your product online at: www.nutone.ca/register.asp