NuTone ERLE1 Series Installation Use And Care Manual

Also see for ERLE1 Series: Installation use and care manual

INSTALLATION MANUALINSTALLATION20Install the Hood (Standard Installation)1 ] Run house power cable between service panel and hood location. For hood with power cableaccess located on back of hood, run the house power cable into the hood through the strainrelief previously installed in step 6 on page 11. For hood with power cable access located on top,tighten the strain relief to the power cable before inserting the strain relief in the knockout hole.2 ] Hang hood from (2) rear mounting screws previously installed. Slide hood back towardswall until mounting screw heads are engaged in narrow end of keyhole slots in top of hood.Tighten screws securely and maintain a hold on the hood until completing step 3.3 ] Secure the hood to the cabinet using two (2) no. 8 x 5/8” round head wood screws (includedin parts bag). Insert one (1) screw per side, in the slots (as shown below). Attach power cableto the hood using the strain relief.4 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.Make sure the damper assembly (or round duct plate) enters the ductwork and that the damperopens and closes freely.DUCTED INSTALLATION ONLYOTE:N Two installers are recommended because of the weight of this hood.BACK OF HOODScrew previouslytighten in step 2.