model nsp130Page 5 Remove Vertical duct Knockout or Horizontal ductKnockout and attach damper / duct connector withtwo (2) screws (supplied).VERTICAL DUCTKNOCKOUTHORIzONTAL DUCTKNOCKOUTDAMPER /DUCTCONNECTORinstall tHe HoodwarningTo reduce the risk of electrical shock, switch power offat service panel. Lock or tag service panel to preventpower from being switched on accidentally.6 Run House power cable between service panel andhood location. Attach power cable to hood using appropri-ate connector.7 Hold the hood in position under the cabinet. Make surethe damper / duct connector enters the ductwork andthat the damper opens and closes freely.8 Tighten the four (4) mounting screws completely to se-cure the hood to the cabinet.HOUSEPOWERCABLEMOUNTINGSCREWS (4)DUCTWORKconnect tHe wiringHE00599 Connect House power cable to range hood wiring- BLACK to BLACK, WHITE to WHITE, and GREEN orBARE WIRE to green ground screw.HOUSEPOWERCABLEGREENGROUNDSCREW10 Re-install the wiring cover, bottom cover, and filters thatwere removed in Step 3.complete installation11 Install Halogen Bulbs. Use 120 V, 50 W, shielded halo-gen bulbs - MR16 or PAR16 with GU10 base. Purchasebulbs separately.install ligHt BulBs(1) PUSH IN(2) ROTATECLOCKWISE