NuTone Premier NP51000 Series Instruction Manual

Contents

NuTone Premier NP51000 Series Instruction Manual Manual pdf 11 page image

- 11 -OPERATIONControlsThe hood is operated using the slide controlsunder the bottom of the hood.The light switch turns the lamps on and off.The blower switch :makes it possible toselect the motor operating speed. Position 0:motor off.The pilot lamp lights up whenever the bloweris on.HEAT SENTRY™Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is adevice that will turn on or speed up the blower if it senses excessive heat abovethe cooking surface.1) If blower is OFF - it turns blower ON to HIGH speed.2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.When the temperature level drops to normal, the blower will return to its originalsetting.WARNINGThe HEAT SENTRY thermostat can start the blower even if the hood is turnedOFF. When this occurs, it is impossible to turn the blower OFF with its switch.If you must stop the blower, do it from the main electrical panel.LIGHTSWITCHPILOTLAMPBLOWERSWITCHHALOGEN BULBSThis range hood requires two halogen bulbs(Type JC, 12Volt, 20 Watt Max, G-4 Base).ALWAYS SWITCH OFF THE ELECTRICITYSUPPLY BEFORE CARRYING OUT ANYOPERATIONS ON THE APPLIANCE.To change bulbs:1. Loosen the ring nut by turning itcounterclockwise.2. Remove the bulb by pulling sideward(DONOT ROTATE). CAUTION: BULB MAY BEHOT!3. Replace with Type JC, 12Volt, 20 WattMax, G-4 Base halogen bulb. Do not touchreplacement bulb with bare hands!RING NUT