NuTone VX475CC User Manual

Also see for VX1040CC: Installation tips & user guide Operating instructions Installation instructions

Contents

NuTone VX475CC User Manual Manual pdf 11 page image

page 11MAINTAINING THE POWER BRUSHHOW TO CHANGE BELT1. Turn power brush over andusing a Phillips no. 2 screwdriver,remove the 3 brush roll coverretaining screws (Fig. 6) andset aside.2. Remove brush roll cover.(Fig. 7)3. To free brush roll frombase, start by sliding thebelt side end and pullbrush roll sideways (1).Once disengaged fromhousing, lift brush roll (2)out of its compartment(Fig. 8).4. Disengage brush roll fromworn belt and extract the beltfrom motor shaft by atwisting motion in the enlargearea (I) specifically made forthat purpose (Fig. 9).5. Install new belt by reversing steps 4 to 1.NOTE: To ease belt replacement, start by inserting one endaround the motor shaft in the enlarged area (I). Insertbrush roll through belt until belt is seated in its place.Push down brush roll back in place.WARNINGDisconnect electrical supply before servicing orcleaning the unit. Failure to do so can result inelectrical shock or personal injury from cleanersuddenly starting.!AB0011FIG. 6FIG. 7FIG. 8FIG. 9B ELT B RUSH ROLL12I2R ETAININGSCREWSAB0010AB0012AB0013WARNINGMotor shaft can become hot during normal use. Toprevent burns, avoid touching the motor shaftwhen replacing the drive belt.!HOW TO CHANGE BRUSH ROLLReplace brush roll when brush roll brissles are worn to thebase support bars level.1. Turn power brush over and using a Phillips no. 2 screwdriver,remove the 3 brush roll cover retaining screws (Fig. 6)and set aside.2. Remove brush roll cover. (Fig. 7)3. To free brush roll from base, start by sliding the belt sideend and pull brush roll sideways (1). Once disengagedfrom housing, lift brush roll (2) out of its compartment(Fig. 8).4. Disengage brush roll from belt. Discard worn brush roll.5. Insert new brush roll through belt until belt is seated in itsplace. Push down brush roll back in place.6. Finalise the installation by reversing steps 2 to 1.SERVICE INFORMATIONTo avoid unnecessary service calls, check the belt and brushroll often. Replace the belt if it is stretched or cracked. Cleanthe brush roll bristles when they are wrapped with thread andhairs. Build-up could cause the brush to rotate unevenly.The model number and serial number are indicated on the ratinglabel located underneath the power brush. Always refer tothese numbers when inquiring about service.NOTE: The motor is permanently lubricated and sealed. Donot oil the motor at any time.POWER BRUSH SERVICE PARTSK EY N O. PART N O. D ESCRIPTION1 09234 Belt2 09233 Brush roll3 09236 Brush roll cover with screws4 09235 Wand release pedal5 18651 WandOrder Service Parts by “Part No.”, not by “Key No.”12AA0002453