NuTone WS130BL Installation Manual

Also see for ALLURE WS1 SERIES: Installation instructions Instructions Instructions Manual

ALLURE TM WS1 SERIESNuTone ° .o .oooPage 3PREPARE THE HOOD PREPARE THE HOODEl Remove AIR CHUTEDamper/DuctConnector frominside the hood.Set connec-tor aside - withmounting screwsand parts bag.ElDAMPER/DUCTCONNECTORRemove Wir=Cover frominside the hood.Set cover andmounting screwaside.53 Remove AirChute- held inplace with one(1) screw.NOTE: Be care-ful not to discon-nect any wires.El Remove Bafflefrom air chute.WIRINGCOVERRemove eithertop or back wir-ing knockout andinstall approvedElectrical CableClamp_.ELECTRICAL CABLE CLAMPNon-Ducted installation - Skip to "ConnectWiring"section.The followingSteps (6 thru13) are for _!iiii;DUCTEDINSTALLATIONONLY.(3) #8 SCREWS LIGHTPANELBAFFLERotate baffle. Re-insert baffle into airchute (as shown) sothat baffle tabs fit allthe way into slots inair chute. An audible"click" will be heardwhen fully installed.This will close offthe air flow throughthe non-ducted slotson top of hood.SLOTSBAFFLE\TABSEl Remove L_ght Panel - held in place with (3) #8 screwsand (2) #8 screws. Disconnect light assembly wire harness(white connector).Re-install air chute, re-connect wireharness, and replace light panel.NOTE: Be careful not to trap wiresbetween _ort fin and light panel. SUPPORT FIN