Nuvo NV-P100 Series Product Manual

Also see for NVGW100 series: Product manual Product manual Manual

Contents

Nuvo NV-P100 Series Product Manual Manual pdf 14 page image

NUVO®The NVP100-xx and NXP200-xx zone players are equipped with “5-way” binding posts for connecting the amplified audiosignal to speakers. Speakers can be bookshelf, floor-standing, or installed in the wall or ceiling. 16 gauge speaker wireis recommended for this purpose. The binding posts allow multiple methods for terminating the wire. The post can beunscrewed to expose a hole for the speaker wire. After stripping about 1/4 inch of insulation from the inner conductor wire, it can be inserted into the hole. Screw the post back in until it firmly secures the wire, as shown in Fig 7. An alternativemethod is to terminate the speaker wire into “banana” plugs and insert those into the end of the binding posts, as shownin Fig. 8. Spade, pin, and wrapping are alternative connection methods. Be careful to keep the positive and negativespeaker connections consistent at both ends. Crossing the left and right terminations will inhibit the audio quality fromthe amplifier.Fig. 7Fig. 9Fig. 8The P3100 and P3500 zone players have three separate zone “euro” style speaker connectors. The speaker wire is termi-nated into this modular plug and then inserted into the appropriate zone output on the back panel of the P3100, as shownin Fig. 9.It is only necessary to strip about 1/8 inch of the insulation from the inner conductor for these plugs. Be carefulnot to let the exposed speaker wires touch. This will short the connection and could damage the amplifier.1.4 Connecting Speakers to the NVP100-xx and NVP200-xx1.5 Connecting Speakers to the NVP3100-xx and NVP3500-xx14