Restoring the DGX-2 Software ImageDGX-2 System User Guide 47OBTAINING THE DGX-2 SOFTWARE ISO IMAGEAND CHECKSUM FILETo ensure that you restore the latest available version of the DGX-2 software image,obtain the current ISO image file from NVIDIA Enterprise Support. A checksum file isprovided for the image to enable you to verify the bootable installation medium that youcreate from the image file.1. Log on to the NVIDIA Enterprise Support site.2. Click the Announcements tab to locate the download links for the DGX-2 softwareimage.3. Download the ISO image and its checksum file and save them to your local disk.The ISO image is also available in an archive file. If you download the archive file, besure to extract the ISO image before proceeding.RE-IMAGING THE SYSTEM REMOTELYThese instructions describe how to re-image the system remotely through the BMC. Forinformation about how to restore the system locally, see Re-Imaging the System from aUSB Flash Drive.Before re-imaging the system remotely, ensure that the correct DGX-2 software image issaved to your local disk. For more information, see Obtaining the DGX-2 Software ISOImage and Checksum File.1. Log in to the BMC.2. Click Remote Control and then click Launch KVM.3. Set up the ISO image as virtual media.a) From the top bar, click Browse File and then locate the re-image ISO file andclick Open.b) Click Start Media.4. Reboot, install the image, and complete the DGX-2 System setup.a) From the top menu, click Power and then select Hard Reset, then click PerformAction.b) Click Yes and then OK at the Power Control dialogs, then wait for the system topower down and then come back online.c) At the boot selection screen, select Install DGX Server.If you are an advanced user who is not using the RAID disks as cache and wantto keep data on the RAID disks, then select Install DGX Server without formatting
