Using DGX-2 System in KVM ModeDGX-2 System User Guide 93B.7. System Access WarningsCaution: To avoid personal injury or property damage, the following safety instructionsapply whenever accessing the inside of the product : Turn off all peripheral devices connected to this product. Turn off the system by pressing the power button to off. Disconnect the AC power by unplugging all AC power cords from the system or walloutlet. Disconnect all cables and telecommunication lines that are connected to thesystem. Retain all screws or other fasteners when removing access cover(s). Upon completionof accessing inside the product, refasten access cover with original screws orfasteners. Do not access the inside of the power supply. There are no serviceable parts in thepower supply. Return to manufacturer for servicing. Power down the server and disconnect all power cords before adding or replacingany non hot-plug component. When replacing a hot-plug power supply, unplug the power cord to the powersupply being replaced before removing the power supply from the server.Caution: If the server has been running , any installed processor(s) and heat sink(s)may be hot.Unless you are adding or removing a hot-plug component, allow the system to coolbefore opening the covers. To avoid the possibility of coming into contact with hotcomponent(s) during a hot-plug installation, be careful when removing or installing thehot-plug component(s).Caution: To avoid injury do not contact moving fan blades. Your system is suppliedwith a guard over the fan, do not operate the system without the fan guard in place..