Nxg NX-RF200 Installation Manual
                | |
Frequently Asked QuestionsCan I use flasher/emitters that I have already installed in the system toconnect to the NX-RF200?Yes, the flashers are compatible if they use 3.5mm mono mini plugs withthe same polarity (Tip is data, sleeve is ground).I’m getting inconsistent operation regardless of flasher level orposition.Some components are easily overloaded with IR from nearby flashers.Prevent IR from affecting the problem component from other flashers orthe front panel blaster by setting the device to a specific IR Line Outputinstead of ALL, then adjust the Line Output.I have a row of identical TVs. I’ve correctly set the flasher outputs usingthe Editor software, yet when I send a command to one of them, the TVnext to the selected TV also responds. How do I stop this?First, check the RF ID#, if the RF ID# is set to 0, IR routing does not work.Second, set the RF ID# from 1-9 or A-F on both the remote control and therear of the NX-RF200. Third, check that the flasher level is set to the mini-mum necessary. Fourth, check that the emitter is facing the component.SpecificationsPower Supply: 9V 300mAIR Flasher Line Outputs: 3.5mm Mono Mini JackRF Frequency: 418MHzNX-RF200 Base Station12NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 15 |
Related manuals for Nxg NX-RF200
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine