20 SERVICE MENU• Turn the potentiometer, until the special digit „u“ appears in the servicedisplay.• By pressing the key rpm/rcf the display „rpm/rcf“ is now activated and youcan setup the respective option with the potentiometer.• At the end of the run you can now hear the audible sound in the setupvolume whereas 0 is the most quiet setup and 9 the loudest one.Attention: After all points have been reviewed and/or set up, you have topress shortly the key start to store all parameters. Otherwise the setups wereall for nothing. If the storage has been successful in the display „rpm/rcf“ thevalue of the imbalance sensor and the word „StorE“ are indicated.2.1.10 Submenu Setup of the signal melodyHere you can setup the melody at the end of the run in case the signal generator is activated.• Activate the operation menu as described under „Activation of the operationmenu (Part 1)”.• Turn the potentiometer, until the special digit „G“ appears in the servicedisplay.• By pressing the key rpm/rcf the display „rpm/rcf“ is now activated and youcan setup the respective option with the potentiometer.• Now the setup melody will be played by the end of the run, whereas you canchoose between 0 and 9 setups (anyway 10 melodies).Attention: After all points have been reviewed and/or set up, you have topress shortly the key start to store all parameters. Otherwise the setups were