OHAUS Pioneer Instruction Manual

Also see for Pioneer: Service manual Instruction manual Instruction manual

Contents

OHAUS Pioneer Instruction Manual Manual pdf 5 page image

EN-3 Pioneer™2.3 Level BalanceLevel the balance on a firm, steady surface. Avoid locations with excessive air current, vibrations, heat sourcesor rapid temperature changes.2.4 Connect Power2.5 Initial CalibrationWithout InCal – Power on the balance by pressing 0/T. Press and hold Print/Cal until [CAL] is displayed.The display flashes the calibration mass needed. To select the alternate calibration weight press No. Putthe calibration mass on the pan. The display flashes [BUSY], then [CLEAr Pan]. Remove the mass. Whencalibration is complete, [DONE] is displayed.InCal – Press and hold Print/Cal until [CAL] is displayed. The display flashes [BUSY], when calibration iscomplete, [DONE] is displayed.Note: Calibrations should be performed after a warm up time of 60 minutes.3. OperationCount, APW Optimization, Percentage or specific units of measure must be activated in the MODE or UNIT menusif they are not initially available.3.1 Weighing ModeRepeatedly press Unit until the desired unit icon is displayed.Press 0/T to zero the balance and then place objects to be weighed on the pan.3.2 Count Mode – Use the Count mode to count parts of uniform weight.To access Count Mode, press Unit until the display shows [Count].Establish an Average Piece Weight (APW) – Each time a new type of part is to be counted, the nominal weight ofone piece (APW) must be established using a small quantity of pieces.With [CLr.APwW] displayed, press No to use the previously saved APW, or press Yes to establish a new APW. Thedisplay indicates the number of pieces to be used to establish the new APW. If a different sample size is preferred,press No until the desired sample size is displayed (5, 10, 20, 50 or 100). Put the specified number of pieces onthe pan. Press Yes to accept new APW or No to abort.Count – Place the quantity to be counted on the pan.APW Optimization – Since the weight of each piece varies slightly, APW Optimization may be used to increase theFor use with CSA Certified (orequivalent approved) powersource, which must have alimited circuit output.