OHAUS Ranger Count 3000 Series Instruction Manual

Also see for Ranger Count 3000 Series: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Ranger™ Count 3000 Series EN-154.3 Setup MenuEnter this menu to set scale parameters. Default settings are in bold.Reset [reset]Reset the Setup menu to factory defaults.NO = not resetYES = resetDual Scale [d.scale]Set the status of the second scale input (Scale 2).OFF = disabledON = enabledCap2 [CAP2]Set the capacity of Scale 2.1…9999Grad2 [GrAd2]Set the readability of Scale 2.0.00005…0.5Power on unit [pwWr.UN]Set the unit of measure displayed at startup.AUTO = last unit in use when turned offkg = kilogramsg = gramslb = poundsoz = ounceslb:oz = pound ouncesZero Range [ZErO]Set the percentage of scale capacity that may be zeroed.2% = zero up to 2 percent of capacity10% = zero up to 10 percent of capacityAuto Opt [A.OPt]Set the Automatic Optimization.OFF = disabledON = APW automatically optimizedReset: no, yesDual Scale: off, onCap2: 1…9999Grad2: 0.00005…0.5Power on unit: auto, kg, g, lb, oz, lb:ozZero Range: 2%, 10%Auto Opt: off, onAuto Tare: on, off, on-accBeeper Opt: off, onBeeper Signal: off, accept, under, over, under-overBeeper Key: off, onAccumulation: off, auto, manualEnd Setup: Exit menu