OHAUS STARTER 3100C Instruction Manual

Also see for STARTER 3100C: Instruction manual Service manual Service manual Instruction manual

Contents

STARTER 3100C Bench Conductivity Meter EN-13The details for the second line are:Auto EP, 85.1μS/cm, 26.8°C, ATC| | | |---- Auto Temp. Compensation| | |----------------Temperature value and unit| |------------------------- Conductivity value|---------------------------------------- Auto End PointThe details for the third line are:Ref.25°C , T.Comp.Coeff. 2.00%/°C| || |---------------- Temperature compensation coefficient value|------------------------------------------- Reference temperature, 20 or 25 °CThe format for the print-out following a TDS measurement is:End Point, Value, Temp., ATC/MTCManual EP, 38.0mg/L, 23.2°C , ATCRef.25°C , T.Comp.Coeff. 2.00%/°CTDS-F 0.5The format for the print-out following a Salinity measurement is:End Point, Value, Temp., ATC/MTCManual EP, 0.08psu, 25.0°C , MTCThe print-out in case of an error message is:End Point, Value, Temp., ATC/MTCError4The print-out for a successful calibration is:Standard: 1413μS/cmTemperature: 30.0 °CCalibration value: 1552μS/cmCell Constant: 1.66 cm-1ATC/MTC: ATCPrinting from memory When scrolling through the memory you can print the entry that is currentlyviewed by pressing and holding for 2 seconds. The printout format is followings:Recall 08:EndPoint, Value, Temp., ATC/MTCAuto EP, 68.8μS/cm, 26.8°C , ATCRef.25°C , T.Comp.Coeff. 2.00%/°C