Ethernet Interface EN-7ETHERNET CONFIGURATIONTo set the Ethernet parameters per web.1. Make sure the Ethernet Interface Kit is installed properly and network cable isconnected to a computer (PC).2. Set the PC to obtain an IP address automatically as shown below.3. Open the IE Browser and enter the default IP address of the EthernetInterface Kit "169.254.1.1" ( ), the browser willshow below page:4. Click the "Network Configuration" on the left side, and input the user &password. Then click "OK" to proceed.5. Input the Ethernet parameters in the following page, click “Save Config“ tosave the changes.Note: To use DHCP, enable the DHCP:User: ohausPassword: ohaus

ethernet connection

ethernet configuration

OHAUS Scout Instruction Manual

Introduction

Tools and Test Equipment Required

Specifications

Operation

Transducer Operation

Power Supply

Low Voltage Detector

Half Bridge Emulator

Block Diagram

Diagnostic Guide

Error Codes

Preventive Maintenance Checklist

Testing

Calibration

Performance Tests

Off-Center Load Test

Down Stop Adjustment

Replacement of Major Components

Disassembly

LCD Display (12) Replacement

Transducer (8) Replacement - 200 Gram Models

Transducer (8) Replacement - 400 and 600 Gram Models

Parts Lists

Replacement Parts List

SCOUT

rs232 interface